Electrónica de consumo

Hogar Electrónica de consumo RFQ de divisor de haz: Definir la relación en las condiciones de operación

RFQ de divisor de haz: Definir la relación en las condiciones de operación

Indagación
  • Descripción

Un 70/30 marking does not tell a supplier which port should receive more power or under what conditions to verify it. Define the reflected and transmitted paths in a sketch, then specify how to measure the ratio.

Label the Beam Paths

Mark the input, the transmitted port, and the reflected port. Identify the input face, nominal incidence geometry, and effective beam diameter. For a plate or cube substitution, ask for a revised interface drawing before accepting it. Mechanical fit alone does not establish an equivalent beam path.

Define the Measurement

Specify wavelength or band and input polarization. Decide whether acceptance is evaluated at a single condition or across a range. If collected power matters, state minimum power at the ports or define the loss budget. A ratio between outputs does not establish total throughput.

Lista de verificación RFQ

  • Port and input-face diagram
  • Wavelength, incidence geometry, and polarization
  • Ratio convention, tolerance, and throughput requirements

Any cosmetic acceptance requirement should separately explain how to inspect for scratches and digs.

Referencia técnica: edmundoptics.com.

CATEGORÍA Y ETIQUETAS:
Electrónica de consumo

ENVIAR CONSULTA

Nombre *

Correo electrónico *

Teléfono

Mensaje

Verificación *     + = ?

Productos relacionados