Ресурс

Дом Ресурс Optical Flat Fringe Reports: Define the Test Area

Optical Flat Fringe Reports: Define the Test Area

Запрос
  • Описание

An optical flat is a reference, and a fringe image describes a comparison against that reference in a particular setup. Before comparing two supplier reports, confirm that both measure the same surface, over the same usable area, under comparable illumination and support conditions. A photograph with visible fringes but no scale, region or setup record is difficult to use at incoming inspection.

Optical flat diagram showing light reflecting from two surfaces and producing interference fringes.
Concept illustration: Chetvorno / Wikimedia Commons, CC0 1.0. Diagram, not a SilverOptics measurement.

Distinguish slope from shape

The air gap between the reference and the part can change steadily across the field, producing straight bands because of the wedge. Counting those bands across the full field does not by itself give the surface flatness error. Ask the supplier to show where the fringes bend relative to their local spacing, and whether the reported result is from a qualitative fringe comparison or an evaluated measurement.

Put the aperture on the drawing

Identify the tested face and the optical area used for acceptance, including any allowed edge exclusion. Request the reference identification, illumination wavelength, support condition and the viewing orientation. If the measurement uses an interferometer, state the reporting convention and any data treatment in the acceptance plan rather than assuming an optical-flat photograph and a wavefront map are interchangeable.

Request evidence that can be reviewed later

Ask for the marked evaluation region, sample and lot identity, drawing revision and setup note with the report. Where a supplier proposes a different method, agree which observable is comparable before shipment. Keep the setup record with the sample acceptance package so a later disagreement can be traced to the part, region or method.

For quote preparation, use the SilverOptics RFQ form. Техническая информация: Edmund Optics application reference.

КАТЕГОРИЯ И ТЕГИ:
Ресурс, Блоги

ОТПРАВИТЬ ЗАПРОС

Имя *

Отправить по электронной почте *

Телефон

Сообщение

Проверка *     + = ?

Сопутствующие товары