WhatsApp: +86 13530516428 Tel: 0755-23089686     sales@silveroptics.net

Consumer Electronics

Home Consumer Electronics Optical Window RFQs: Separate Surface Flatness, Wedge and Wavefront

Optical Window RFQs: Separate Surface Flatness, Wedge and Wavefront

Inquiry
  • Description

An optical window can meet a surface flatness requirement but still deflect a beam if its faces are not parallel. Conversely, two nearly parallel faces do not guarantee the transmitted wavefront required by an imaging system. Buyers should separate the effects they need to control rather than putting a single “optical quality” note on the drawing.

Assign a requirement to each failure mode

Surface flatness describes how closely a face follows a plane. If you specify it in waves or fringes, state the test wavelength and agreed reporting convention. Identify which face and which clear aperture the figure covers. A flatness result for one face is not a measurement of the transmitted performance of the assembled optic.

Wedge describes the angle between the faces. It may be an error in a window intended to transmit along the nominal axis, or a deliberate design feature for managing unwanted reflections. If wedge is deliberate, specify its nominal direction relative to a usable mechanical datum and mark the orientation in the assembly drawing.

Transmitted wavefront error is a through-part result. It can reflect the combined effects of the faces and variations in the bulk material. State the incidence geometry, wavelength, clear aperture, and which terms may be removed in reporting. If the item is used in a clamped holder, decide whether acceptance is for the loose window, the mounted window, or both.

Make the acceptance evidence reproducible

  • Show clear aperture and any exclusion zones on a dimensioned drawing.
  • Define material, thickness, coating state and which side is presented to the instrument.
  • Agree on the support method and whether coating or installation happens before the optical test.
  • Ask for the result and the setup conditions on the same report. If orientation matters, keep the part marking traceable to the measurement.

Some windows only need a wedge or beam deviation requirement, while others justify a through-part wavefront test. Share the actual system concern with the supplier so both sides can quote the relevant controls instead of adding every metrology option by default.

Technical background: Edmund Optics’ guide to optical windows.

CATEGORY AND TAGS:
Consumer Electronics

SEND INQUIRY

Name *

Email *

Phone

Message

Verification *     + = ?

Related Products